antennas.us made products

The UL-1400-D345USM is a versatile, Dual Band, US Cellular antenna. It measures 4 cm/1.5" OD x 11 cm/4.5" H and is designed to conveniently mount onto any structure, by means of a single 1/4" (6.4 mm) hole. Its internal radiating structure is self-contained and operates well with or without a ground plane. Therefore, it can be mounted on a non-conductive support, as needed by your application. Use this product with any Cellular/Mobile telephone, modem or transceiver, having an SMA connector...

A broadband, rugged, mobile radio antenna featuring a high ESD (ElectroStatic Discharge) isolation. With modest dimensions of 1.5"/4 cm (OD) x 4"/10 cm (height), this antenna radiates with a typical peak omnidirectional gain of +5 dBil, when mounted on a large metal surface of at least 16"/40 cm radius. This antenna will survive a 20 ft drop onto asphalt and continue operating (see Drop Test results) Internally, the radiating element is DC grounded and the feedpoint is DC isolated beyond 1 kV....

Universal Type N Female connector Mount and Cable Assembly. Type N Female jack/receptacle at one end of LMR-195 coaxial cable (Teflon insulator, 0.2" OD). Select cable length and other end connector.

The UL-3502-438 is a rugged, wideband, omnidirectional, medium gain, linearly polarized antenna, covering the licensed WiMax 3.5 GHz band. It measures 4 cm/1.5" OD x 11 cm/4.5" H and can be used either indoors or outdoors. SPECIFICATIONS: Frequency range: 3.4-3.7 GHz Coverage: Omnidirectional in azimuth Polarization: Linear, typically mounted for Vertical polarization (VPOL) Gain: +5 dBil Nominal Impedance: 50 ohm (RF) Input Power: 10 Watt CW VSWR: 2.0 Connector: SMA, Female (select preference...

Wideband, Low Profile Transit Antenna/UHF Train Antenna (430-470 MHz) A broadband, rugged, mobile radio antenna designed to service the whole 430-470 MHz UHF band, featuring a DC grounded radiating element. It may be used as a UHF Train Antenna on locomotives and Railroad related applications, such as End-of-Train Devices (EOT/ETD) or Head-of-Train Devices (HOT/HTD). It is also ideally suited as a Transit Antenna, for installation on buses, subway/metropolitan rail assets and stations, or as a...

Leadtime: 4 Weeks ARO X-Band, Omnidirectional Antenna, Description This antenna was originally designed to be used by RACONs, or RAdar beaCONs: a device normally used to mark the location of a Lighthouse or a Marine Buoy, as an aid to maritime navigation. RACONs operate within the X-band range of 9.32-9.50 GHz. Traditionally, a RACON signal identified itself on a radar screen as a dash line, followed by a Morse Code signature. The SL-9402-386 was developed as the antenna component of a RACON...

Puzzle: Maze Download Puzzle (PDF)

New Product - Available early 2022 Q2 Leadtime: 4 Weeks ARO X-Band, Wideband +5 dBil VPOL Omnidirectional Antenna, Description This antenna was developed as a Vertically Polarized (VPOL) companion/option to our SL-9402-386 HPOL model. Like its counterpart, the SL-9401-700 antenna was designed to offer comparable gain, at +5 dBil. Dimensions were kept similar, enabling a very stable and low VSWR across the entire X-band spectrum. In free space, the antenna exhibits a nominal gain of...

UHF Satcom 4-way Combiner/Splitter Four-way RF Splitter/Combiner designed to add the energies of 4 UHF Satcom antenna elements. The combination of four properly spaced and aligned elements comprising an antenna array can produce a passive gain up to +15 dBic. Antenna elements may be 4 of our X-wings (UC-3004-381R or UC-3004-481R) and a reflector, or 4 of our MILSATCOM Quadrifilar Helix (QFH) Antennas, model UC-3004-531R (no reflector required). This splitter/combiner is compatible with both...

Custom VHF Preamplifier and Filter description User specified Custom VHF Preamplifier (LNA) and Filter, model LNAU-0150-648-CF, is a VHF LNA and Filter combined into a single device. It was designed with Software Defined Receivers (SDRs) in mind, which are notorious for performing poorly where there is a high density of signals in close proximity. This is particularly true of low-cost USB SDR dongles, which cover a wide spectrum of frequencies with a few components. The LNAU-0150-648-CF...

UHF Satcom MUOS Diplexer description DPLU-0310-680 MUOS Diplexer, isolates new MUOS Downlink (RX) signals from Uplink transmitted energy. It also manages Legacy and Modern waveforms available from MUOS payloads, enabling a single antenna to support all UHF Satcom modes supported by existing field radios. Currently, a separate RF connector is required for the MUOS WCDMA downlink. This Diplexer supports such requirement. Diplexers are bidirectional and linear. This means that the direction of a...

EXPORT CONTROLS APPLICABLE Leadtime: 4 Weeks ARO TECHNICAL SPECIFICATIONS: Frequency range: 0.7-7.0 GHz Coverage: Broadside Polarization: Circular, RHCP or LHCP, depending on mounting orientation Gain: -2 to +2 dBic Nominal Impedance: 50 ohm (RF), Short Circuit (DC)* VSWR: 3.0 GRAPH Connector: SMA, Female Size: 31 cm (12") x 31 cm (12") x 1 cm (.4") NOTES: Does not require a ground plane * We can provide this antenna with a DC Open Circuit impedance ...

Model VL-1460-496 is a small Amateur VHF Antenna (145-148 MHz, 2m Amateur Radio Band), designed for mobile platforms (vehicles) with height restrictions. Measuring only approximately 4" (10 cm) in diameter and 6" (15.3 cm) tall, this antenna is a very efficient Low Profile radiator. When installed properly on the metal chassis of a vehicle, the VL-1460-496 will perform comparably with a full size 1/4 wave monopole antenna. For optimum operation, install near the center of a flat surface, such...

UHF LOS/Satcom 2-way 180° Combiner/Splitter/Stacker Two-way RF Splitter/Combiner designed to add or subtract the energies of 2 UHF Line of Sight (LOS) or UHF Satcom antenna elements. The combination of two properly spaced and aligned elements comprising an antenna array can produce a passive gain up to +5 dBil/dBic. The form factor of the SPLU-3002-700 is designed to accommodate 2 of our UL-3001-340SN, or similar antennas to produce a colinear array of +4 dBil to +5 dBil gain. Attach an...

ADS-B Splitter / L-band 2-way Combiner/Splitter L-band, two-way, 0° RF Splitter/Combiner designed to distribute dual band ADS-B signals to two receivers, often Software Defined Receivers, like a pair of RTL-SDRs. Intended to be the final stage of a full ADS-B upcoming receiving station kit (UL-ADSB-KIT), the Splitter's job is to deliver DC power to an outdoor ADS-B Low Noise Amplifier, like our LNAU-1030-648 via a coaxial cable. At the same time, and through the same coaxial cable, ADS-B...

LOS/Satcom Superdirective Endfire Array Feeder (2-way Phasing Splitter/Combiner) description The SPLU-3002-711 is an UHF Line of Sight (LOS)/Satcom Superdirective Endfire Array Feeder (2-way Phasing Splitter/Combiner) designed to produce a Supergain Endfire Array from two constituing elements directly mounted at its output ports. You can obtain an approx. 5 dBi unidirectional beam antenna by connecting two identical or similar omnidirectional antennas at each output. The terms "Superdirective"...

Puzzle: Double Phrases related to Electromagnetism, Fields and Antennas Download Puzzle (PDF)

The VL-1461-383 is a full-size, VHF omnidirectional antenna covering the Amateur 2 meter band (144-148 MHz). The internal radiating structure is balanced and complementary, and no ground plane is needed or required for normal operation. The antenna is housed in a Fiberglass enclosure making it rugged and tolerant to challenging environments. Internally, the feedpoint is DC shunted (short circuit) and electrically grounded (if mounted onto a grounded mast/structure), offering limited...

Amateur Radio 6 Meter Band, 50-54 MHz Omni Antenna The VL-5201-383 is a half-size, omnidirectional antenna covering the Amateur 6 meter band (50-54 MHz). In spite of its small size, this antenna will rival any full size equivalent. The internal radiating structure is complementary, and no ground plane is needed or required for normal operation. The antenna is housed in a Fiberglass enclosure making it rugged and tolerant to challenging environments. Internally, the feedpoint is DC shunted...

The VL-4401-383 is a half-size, omnidirectional antenna covering the Low Band VHF Fire and Public Safety spectrum (42-46 MHz). In spite of its small size, this antenna will rival any full size equivalent. The internal radiating structure is complementary, and no ground plane is needed or required for normal operation. The antenna is housed in a Fiberglass enclosure making it rugged and tolerant to challenging environments. Internally, the feedpoint is DC shunted (short circuit) and...

The VL-2051-383 is an omnidirectional antenna covering the entire VHF Digital Audio Broadcast band (DAB, Band III, 174-240 MHz). DAB is the future "FM broadcast" band, popular in Europe and Asia, featuring CD quality audio broadcast over land (terrestrial DAB). The internal radiating structure is complementary and broadband. Thus, no ground plane is needed or required for normal operation. The antenna is housed in a Fiberglass enclosure making it rugged and tolerant to challenging...

The LL-1001-396 is a small, low profile, omnidirectional AM antenna, covering the Medium Frequency spectrum from 600 kHz to 1.6 MHz (AM Band). It may be used as an AM antenna for Mobile homes, and to monitor the MF spectrum in First Responder assets. The internal radiating structure is self-contained: no ground plane is needed or required for normal operation.This antenna is an enhanced loop, thus its feedpoint is DC shunted (short circuit) and electrically grounded (if mounted onto a grounded...

Medium Frequency/High Frequency (MF/HF) Low Profile, Multi-turn Loop Antenna, Custom Tuned The LL-1001-396-CF is a small, low profile, narrowband omnidirectional, Custom Tuned antenna, for narrowband MF or HF operation. Select your desired operating frequency from 0.1 MHz to 30 MHz (MF/HF Band). It may be used as an AM antenna for Mobile homes, and to monitor the MF spectrum in First Responder assets. The internal radiating structure is self-contained: no ground plane is needed or required for...

UC-300-B5, UHF Satcom Antenna, CP Description Leadtime: 4 weeks ARO Antenna model UC-300-B5 is a lightweight, complete UHF Satcom antenna system. The polarization of this antenna is Circular (CP), intended for communications through satellites only. For dual and multi-purpose UHF Satcom applications, visit our custom antennas website at , or look at our other UHF Satcom product offerings at UHF SATCOM/LOS/DAMA/MUOS Antennas catergory within this store. SPECIFICATIONS: Operating Frequencies:...